Key takeaways
- Power enters through the meter and flows to the main breaker.
- Branch breakers protect each circuit and trip when current is too high.
- Neutral and ground bars complete the circuit and provide safety paths.
- Panel size is measured in amps, and capacity depends on your loads.
From the meter to the main
Power from the utility passes through the meter and into the service panel. The main breaker is the master switch for the whole house. Turning it off shuts down every circuit in the panel, which is why it is the first thing to reach in an emergency.
Common residential services are one hundred, one hundred fifty and two hundred amps. Larger homes and homes with electric heat or EV chargers may need more.
Branch breakers and circuits
Below the main are branch breakers, each protecting a circuit that feeds lights, outlets or an appliance. The breaker rating matches the wire size and is a limit for safety. If a circuit draws too much current, the breaker trips to prevent overheating.
Heavier loads such as ranges, dryers and EV chargers use two-pole breakers on 240 volts.
Neutral, ground and bonding
Neutral wires carry current back to the panel to complete the circuit. Ground wires are safety paths that give fault current a route to trip the breaker. In the main panel, neutral and ground are connected, or bonded. In subpanels, they must be kept separate.
Loose or corroded connections on these bars can cause flickering and other odd behavior.
What to do and not do
You can safely reset a tripped breaker by switching it fully off and on. Do not remove the panel cover or touch anything inside, because parts remain live even with the main off. Have a trained electrician handle any work inside the panel.
A warm panel, scorch marks or buzzing are reasons to call right away.
Quick answers
How do I know what size my panel is?
The main breaker is labeled with its amperage, such as 100 or 200.
Is it normal for a panel to buzz?
A faint hum can be normal, but loud buzzing, crackling or heat is not.
Can I add breakers myself?
Adding breakers means working in a live panel and should be left to a trained electrician.




